围栏式打包机使用说明

一、安装操作步骤

1、本机器要平稳摆放在混凝土地面上，机器不能有摆动现象；

2、打开油箱顶部加油口密封盖，然后往油箱里面加入68号或者46号抗磨液压油，加油高度为：离油箱项部100mm高就行了，然后把油箱盖好（注：单油缸打包机在使用时要在左、右附杆打上黄油）；

3、本机器工业电压及频率为：3N-380V-50HZ（出口按当地国家电压及频率订做），三相四线制，三条火线接到电箱里面的接线端口，一条零线接到零线端口，电接好后，把总电源开关打上，把电箱里面开关闭合上，就可以试机，通电后检查电机转向，反转不会往下压，需要把两条电源线调换一下位置，然后才能试机；

4、本机采用电动液压控制：根据控制箱上面按钮图标来操作机器；

5、如果机器试好，压板可以正常上、下；箱体可以正常上，下；多来回操作几次，把油箱和油管里面空气排出，在把物品放进箱体内进行压缩打包；

6、当打好一个包要进行捆扎时，压板压到下面不能在往下压时；把箱体升起来在进行捆包，当捆好包时在把压板升起来取出包块，在把箱体下到底面在进行下一次打包；

7、当机器长时间不使用时，将压板升至顶部，把电箱里面的开关断开，然后关闭总电源。

8、操作有不明白的电话联系，手机：13632810159，赵先生

 Fence type packing machine instructions

A, installation steps

1, smooth the machine to put in the concrete ground, the machine can't have oscillation phenomenon;

2, open at the top of the tank filler sealing cover, and then to the fuel tank in 68, or 46, anti-wear hydraulic oil, oil height is: from an 100 mm happening in the tank, and then put the cap (note: this machine when used in single cylinder on the left and right with rod play butter);

3, voltage and frequency for the machine industry: 3 n - 380 - v - 50 hz (export order according to the local country voltage and frequency), three phase four wire, three wire received from the inside of the box connection port, a zero line to zero ports, electricity connected, the total power switch on, inside the electrical box on the switch is closed, to commissioning, after electrify inspect motor steering, inversion not downward, need a change of position, the two power supply cord before commissioning;

4, the machine adopts hydraulic control: according to the control box button icon above to operate the machine;

5, if the machine well, linking piece can be normal upper and lower; On the box body can be normal, under; Back and forth for a few times more, discharge air inside the tank and oil pipeline, compressed package in the items in the casing;

6, when play a package for strapping, clamp pressure to the bottom not at downward; To the rising of the housing in bales, when good bundle package in to remove the bag piece, the rising of the clamp in the box next to the bottom in the next packaging;

7, when the machine when not in use for a long time, the pressure plate rose to the top, the electricity box inside the switch, and then shut off the main power supply.

8, the operation is not understand of telephone, mobile phone: 13632810159, Mr Zhao